Used on all hot rolled structural steel plates and sections up to a surface hardness of 300 Brinell (32HRc) | Lifts plates from horizontal to vertical position and vice versa through 180º | Clamp has serrated teeth and will mark plate | 0 to 5/8 inch jaw capacity | 1,100 pound working load limit
Precision manufactured and galvanized to meet federal specifications (FF-C-450 Type 1 Class 1) on 1/4" and larger | Drop forged base | Clips are available in two configurations
All shackle bodies and pins are forged from alloy steel, heat treated and tempered | All shackles are marked with size (inches and millimeters) and working load limit in tons | Ultimate strength equals 5 times working load limit | Bolt, nut and cotter shackles have thread protected ends and are 100 percent proof tested | When ordering, specify galvanized (G) or painted (P)
Made of Special Bar Quality (SBQ) steel having fine grain, reduced sulfur and phosphorus | Working load limit and traceability codes shown as permanent markings on body | Shackles meet dimensional and performance requirements of RR-C-271
Manufactured from technically advanced micro alloy steel with optimal hardness for strength and ductility | Working load limit and traceability codes shown as permanent markings on body | Shackles meet dimensional requirements and exceed performance requirements of RR-C-271
Fully machined and heat treated liftwheel with hardened chain guides for smooth chain operation and reduced chain wear | Standard lift 10, 15 & 20 feet, heavy-duty caliper type AC brake | Rugged NEMA 4 control station, 115 volt control circuit | Hoistaloy load chain for smooth operation and maximum chain life | Efficient regenerative braking system to avoid heat generation in power train, made in U.S.A
Testing and approvals: precision manufactured and galvanized to meet federal specifications(FF-C-450 type 1 class 1) on 1/4 inches and larger | Forged steel material, galvanized zinc finish, 1/2" cable/wire size, quantity 50 per pack | Drop forged base 1/8 inches - 5/8 inches | Comes in standard pack
Chain shackle with round pin and galvanized carbon steel construction | 1/2” size | 3 ton working load limit | Shackles have alloy quenched and tempered pins | Meets RRC-271D specifications
Grab and Slip | Forged in the US from high quality carbon steel | Clevis hooks have heat treated pins | Hooks are heat treated and tempered | Finishes include self-colored, painted red, or bright zinc (ASME B633-85 Class Fe/Zn 5, Type III)